E-Powerline

Certification service

Fire Door Inspection in London

Fire doors only work if every part of them works. We inspect the door, frame, seals, hinges and closer as a complete assembly and report on what fails and why.

Assessor completing a fire safety inspection checklist beside a red fire extinguisher
Our prices

Fire Door Inspection prices

Priced on the number of doors and the type of premises. Call or send the quote form for a fixed price.

Fire Door Inspection

Communal fire doors

price on request

Flat entrance doors

price on request

Photographic report

included

Fire door inspections are quoted per building because the price depends on the number of doors and whether flat entrance doors need arranging with residents. We confirm the cost in writing before we attend.

What you get

What the inspection covers

Gaps and alignment

The gap around the leaf is measured on every edge. Too wide and smoke passes; too tight and the door binds. This is the most common failure we record.

Intumescent and smoke seals

Seals are checked along their full length for damage, painting over and missing sections. A door with a gap in its intumescent strip will not perform as tested.

Closers and hinges

Every door is tested to confirm it closes fully onto the latch from any angle, and hinges are checked for correct type, fixings and condition.

Certification evidence

We look for the certification label or plug that identifies the door as a tested assembly, since a door without traceable evidence cannot be assumed to be fire rated.

Photographic report

You receive a written report with photographs and a clear schedule of what passed, what failed and what remedial work each failure needs.

The regulations

What the regulations require

The Fire Safety (England) Regulations 2022 introduced specific duties for buildings with two or more domestic premises. In blocks over 11 metres, responsible persons must carry out quarterly checks of communal fire doors and annual checks of flat entrance doors, and must provide residents with information about fire doors in all such buildings.

A fire door is an assembly, not a slab of timber. The leaf, frame, hinges, closer, seals and glazing were tested together, and changing or damaging any one of them can invalidate the rating. This is why doors that look perfectly sound routinely fail an inspection — the failure is usually a 6mm gap, a painted seal or a closer that no longer shuts the door onto the latch.

The purpose is straightforward. Fire doors are what hold a compartment long enough for people to escape and for the fire service to work. In blocks that rely on a stay put policy, that compartmentation is the policy — if the doors do not perform, the strategy for the whole building does not either.

Who needs one

How it works

Three steps to your certificate

Booked, inspected and certified — usually inside 48 hours from your first call.

01

Book

Call, WhatsApp or send the quote form. We confirm your fixed price and a slot that suits your tenants.

02

Inspect

A qualified engineer attends, carries out the inspection in full and talks you through anything that needs attention.

03

Certify

Your certificate is issued electronically within 24 hours, ready to forward to tenants, agents or the council.

Questions

Fire Door Inspection FAQs

It is priced on the number of doors and the type of premises. Send us the building details or the door count and we will give you a fixed written price before attending.

In buildings over 11 metres with two or more domestic premises, communal fire doors need quarterly checks and flat entrance doors annual checks. Your fire risk assessment may set a different frequency for other premises.

You get a written report identifying the failure and the remedial work needed. Many failures are minor and repairable — adjusting a closer, replacing a seal or fitting correct hinges — rather than requiring a whole new door.

Yes. These need access to each flat, so we normally arrange dates with residents in advance and work through the building in blocks to keep the number of visits down.

Yes. Every door is photographed and the report records what passed, what failed and why, so you have evidence to give a fire officer and a clear schedule of works.

Also available

Other services we provide

Book more than one and we complete them in a single visit — one appointment for your tenants instead of several.

Engineer holding a completed EICR electrical installation condition report on a clipboard

EICR – Electrical Certificate

Priced on the number of bedrooms.

Qualified engineer testing a consumer unit with a multimeter during an electrical installation

Fuse Box Installation

Consumer unit replacement, tested and certified.

Engineer holding a portable appliance tester displaying a PASS result

PAT Testing

Priced on the number of items.

Client feedback

Why clients keep referring us

Rated 5 out of 5
We manage just under forty properties and moved all our gas and electrical compliance across. Scheduling is straightforward, reports come back clean and readable, and tenants have never once complained about the engineers.
Placeholder
Sara K.
Letting Agent, Croydon
Rated 5 out of 5
Called at eight in the evening expecting an answerphone and got a real person. Emergency call-out arrived within the hour and the fuse board was replaced the same night. Hard to fault.
Placeholder
Tunde O.
Landlord, Lewisham
Ready when you are

Book your safety certificate today

Qualified, insured engineers across London. Same-day appointments and certificates issued electronically within 24 hours.