E-Powerline

Certification service

Fire Alarm Installation in London

Fire alarm systems designed to the right category for the building, installed properly and commissioned on completion. Domestic HMOs and commercial premises alike.

Ceiling-mounted fire alarm sounder and detector in a residential property
Our prices

Fire Alarm Installation prices

Priced on the size of the building and the system category required. Call or send the quote form for a fixed price.

Fire Alarm Installation

Domestic and HMO systems

price on request

Commercial systems

price on request

Design and commissioning certificates

included

Every fire alarm installation is priced individually because the category, the number of devices and the cabling route all depend on the building. We survey first, then quote in writing — and the figure we agree is the figure you pay.

What you get

What the installation covers

System design to category

The system is designed to the correct BS 5839 category for the building and its use. Fitting the wrong category is the most common reason an installation fails to satisfy a fire officer.

Detection and sounders

Detectors are selected and sited for the risk in each area, and sounders positioned so the alarm is audible everywhere it needs to be, including bedrooms with the doors shut.

Panel and wiring

Control panel and fire resistant cabling installed to standard, with zones set out so a fire brigade attending knows immediately where the alarm originated.

Commissioning and testing

Every device is tested, sound levels measured and the whole system commissioned before handover, with the results recorded.

Certification and handover

You receive design, installation and commissioning certificates plus a logbook, which is what a fire officer or insurer will ask to see.

The regulations

Getting the category right

BS 5839 sets out system categories, and the right one depends on what the building is for. A shared house needs a different system from a small office, and a licensed HMO different again. Installing a category below what the premises require leaves you non-compliant even though there is an alarm on the wall.

For most commercial premises and any HMO, the fire alarm is not optional. The Regulatory Reform (Fire Safety) Order places a duty on the responsible person to provide appropriate detection and warning, and local licensing conditions for HMOs are usually explicit about what is required.

A system is also only as good as its evidence. Design, installation and commissioning certificates plus a maintained logbook are what demonstrate compliance if a fire officer visits or an insurer asks. Installations without that paperwork frequently have to be re-tested and re-certified from scratch.

Who needs one

How it works

Three steps to your certificate

Booked, inspected and certified — usually inside 48 hours from your first call.

01

Book

Call, WhatsApp or send the quote form. We confirm your fixed price and a slot that suits your tenants.

02

Inspect

A qualified engineer attends, carries out the inspection in full and talks you through anything that needs attention.

03

Certify

Your certificate is issued electronically within 24 hours, ready to forward to tenants, agents or the council.

Questions

Fire Alarm Installation FAQs

It depends entirely on the building — the system category, the number of detectors and the cable routes. We survey the premises and give you a fixed written quote before any work is booked.

That depends on the size and layout of the property and on your local licensing conditions, which vary between London boroughs. We assess the property against BS 5839 and tell you which category applies before quoting.

Yes. Offices, shops, restaurants, warehouses and communal areas in residential blocks. Commercial systems are designed to the category the use and layout require.

Design, installation and commissioning certificates, plus a logbook for recording your ongoing tests. Together these are what evidence compliance to a fire officer or insurer.

Usually. We inspect what is there, test it and tell you honestly whether it can be certified and maintained as it stands or whether parts of it need replacing.

Also available

Other services we provide

Book more than one and we complete them in a single visit — one appointment for your tenants instead of several.

Engineer holding a completed EICR electrical installation condition report on a clipboard

EICR – Electrical Certificate

Priced on the number of bedrooms.

Qualified engineer testing a consumer unit with a multimeter during an electrical installation

Fuse Box Installation

Consumer unit replacement, tested and certified.

Engineer holding a portable appliance tester displaying a PASS result

PAT Testing

Priced on the number of items.

Client feedback

Why clients keep referring us

Rated 5 out of 5
We manage just under forty properties and moved all our gas and electrical compliance across. Scheduling is straightforward, reports come back clean and readable, and tenants have never once complained about the engineers.
Placeholder
Sara K.
Letting Agent, Croydon
Rated 5 out of 5
Called at eight in the evening expecting an answerphone and got a real person. Emergency call-out arrived within the hour and the fuse board was replaced the same night. Hard to fault.
Placeholder
Tunde O.
Landlord, Lewisham
Ready when you are

Book your safety certificate today

Qualified, insured engineers across London. Same-day appointments and certificates issued electronically within 24 hours.